944 Forum
944 Forums >> 924/924 S >> 924 wiper motor parts?
https://www.944online.com/cgi-bin/yabb2/YaBB.pl?num=1481324323

Message started by dlove924s on Dec 9th, 2016 at 10:58pm

Title: Re: 924 wiper motor parts?
Post by anchor on Feb 19th, 2017 at 1:35am
I just took the rear one apart. Hindsight don't take the brush's out you'll have a hard time with the springs. I'm using the BIC lighter springs.

Worm gear to cam gear (wheel) lever to drive wiper and positional contacts to motor.
https://www.youtube.com/watch?v=BJk6gZuPKRE
Paralyzer Finger Eleven

A large flat head screw driver will push out the motor from the end of the worm gear. Then you'll need to rid the magnets of the rust (safety glasses). Computer dust air to remove the whiskers if you use a dremel (brush) tool.

Your choice I used white lithium grease on the gear, link lever, and motor bearing is sealed but the face off to the case I used the same. Since I use it on my reels seemed like a good idea at the time.
EDIT:
I'm having a hard time getting this one (donor) off soaked in PB blaster and vinegar water 24 hours. Tried heat, hammer, vice. Any advise?
EDIT: put my rear motor wiper back together today. Give it some power tomorrow. (1) new PIC
2017-02-16_03_35_03-2.jpg ( 1252 KB | Downloads )
2017-02-16_04_00_07_001.jpg ( 1152 KB | Downloads )
2017-02-15_11_25_39.jpg ( 901 KB | Downloads )
2017-02-20_14_38_26.jpg ( 342 KB | Downloads )

944 Forum » Powered by YaBB 2.6.0!
YaBB Forum Software © 2000-2020. All Rights Reserved.