944 Forum
944 Forums >> 944 S2 3.0 >> S2 wont turn over after clutch master and slave ch
https://www.944online.com/cgi-bin/yabb2/YaBB.pl?num=1563482301

Message started by onedirtdog on Jul 18th, 2019 at 8:38pm

Title: Re: S2 wont turn over after clutch master and slave ch
Post by onedirtdog on Jul 18th, 2019 at 10:15pm
After finding a link to Clarks garage I did a test of the ignition switch, it was fine. I did a continuity check of the red and black wire to the starter solenoid and found it to be open. Upon further exploration I found the red and black connector above the clutch master cylinder and the wire was pulled back enough so it didnt make contact with the other side, Im sure I did this when I replaced the master cylinder. I pushed it back in and the car fired right up.

944 Forum » Powered by YaBB 2.6.0!
YaBB Forum Software © 2000-2019. All Rights Reserved.